Minim osd extra3/28/2023 ![]() Let's start with the Arducam OSD Config native utility. On some resources, they offer, remake the board and power the analog part from digital, but I did not do this, since there is an opinion that interference may appear.įor those who decide to connect from one power source, the scheme will be as shown in the photo.Īt the moment, I have an analog part of it from a video transmitter, which I have already told about in my previous article. It should be noted that if you do not submit 5 volts to the analog part of the board, the fee will be silent. To remove the wire going to the TX of my OSD, I did not, so that he was universal, if I could not use this wire yet. The photo shows the wire for the AIOP controller, which also connects the GPS to one connector. If you use a radio station, you connect parallel to it. The wire to the OSD must be connected to the central contacts: GND, VCC, RX, TX. OSD is connected to the flight controller in the telemetry connector. If you confuse and connect incorrectly, it can go smoke. The controller has a connector for connecting a very uncomfortable, six pin, without protecting "from a fool." All contacts are used for programming, and only 4 contacts are used to connect to the flight controller.įor programming, it remains to find a mini-USB cable.Īs for the four pin connector, then everything is more complicated. The board and adapter covered in a heat shrink film. Eyes run away from the number of versions. As a rule, the archive contains a utility and firmware. For firmware, your utility will be required - Minimosd-Extra Config Tool. You can also install and alternative firmwareThe project is called Minimosd-Extra. Download last version software Arducam-OSD and the firmware can be here. To configure and firmware, the device will require special software, it is called arducam-osd. Therefore, at once, together with MAVLink-OSD, I also took the FTDI Tool adapter v1.0. ![]() MINIM OSD V1.0 had overheated problems when using the camera power from 12 volts, this problem It was solved in version V1.1.ĭue to the fact that HK at the end of 2013 had delivery problems, then I ordered c Rctimer-A mavlink-OSD.įor programming, the FTDI adapter will be needed. Also, MAVLink-OSD has no jumpers to select the type of video signal and combining the digital and analog part. OSD abapturation comes from English on Screen Display, which denotes the display of additional information on the operator's screen.Ĭhinese manufacturers make both flight controllers - HKPliot Mega, Arduflyer and OSD controllers -, mavlink-osd.Įxternally, Minim OSD is not much different from MAVLink-OSD, it's like a mirror copy of the board, where the main chip is rotated at 45 degrees. For users of APM controllers to overlay telemetry data, a special device is developed - Minim OSD. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |